Specifications:
Nominal voltage: 12 VDC
Nominal power: 8 W
Maximum head: 2.5 M (3.5 PSI, 97" H
Maximum flow: 567 l/hr (150 GPH)
Connection size: G 1/4 BSPP
Electrical connector: 3-pin (fan header style)
Motor type: Brushless DC*
Pump bearing type: Polished Sapphire
Size: 2.1”W x 2.1”H x 1.74”D
Weight: 241 g (8.5 oz)
MTBF: 50,000 Service Hours
Description:
The Danger Den MAG II - LE is a great tiny 12 volt pump that
offers more performance than the original CSP-Mag. This highly efficient
pump is packed into a tiny 2.1" x 2.1" x 1.74" thermal plastic housing
and is recommended for watercooled setups with minimal flow restrictions or
situations where space is an issue. However, the small size
and low power consumption of the MAG allows multi-unit installs. Though it will
not increase the flow beyond a single pump unit (150 GPH), it will help obtain
the maximun flow rate possible in the system.
Features:
• Extreme Service Life: This pump is designed with extreme service life (50,000
hours*) This was accomplished by employing several different design patent
pending techniques.
• Bearings: The MAG features dual in fluid bearings, using the best material
available, jewels. These bearings are made of highly polished Sapphire. This is
an extremely hard and long lasting material, often found in expensive watches,
high precision instruments, and gyroscopes used in the aerospace and military industries. The MAG is the first liquid cooling pump to utilize this technology.
• Leak Proof: The MAG has no shaft seal, eliminating the possibility of leaking
occurring due to long term seal ware. The stator assembly has a plastic barrier
between the rotor and the fluid operating on magnetic coupling. The drive and
impeller housing is plastic, to reduce the chance of long term fouling.
• Brushless DC motor: The MAG features a brushless DC motor designed with an
operational component life in excess of 50,000 hours. All heat generating
components are thermal conductive bonded to the aluminium case. This provides a
large heat sink area allowing the motor to run under constant high efficiency.
• Small Size: The CSP-MAG dimensions are 2.1” x 2.1” x 1.74" when compared to a
typical 110V pumps the CSP-MAG uses considerably less space, leaving room in
your case for additional components . We still have the smallest pump currently available to the PC
liquid cooling consumer.
• Direct RPM: The CSP-MAG features a hall sensor that directly reads the rotation
of the impeller. The impeller RPM can be monitored using your standard fan mother
board utilities via the fan port.
• Power Suppy: The MAG requires 12V DC and is equipped with a Tx3 connector.
• Ultra low noise: The pump operates
at a very low noise level due to the sealed motor compartment and improved pump
housing design.
• Easy Installation: Purchase the industrial velcro to mount anywhere in case.
• Ports: The MAG features a top outlet and side. The
pump is now available with G 1/4 BSPP straight fitting ports.
• Finish: The MAG features a new thermal plastic housing
to ensure long term corrosion protection and motor heat transfer properties.
|
|
